Skip to content

Manhole, Lift Station and Wet Well Rehabilitation in Arizona

The Triplex Liner System is a permanent solution for deteriorating sewer structures: a structural fiberglass liner, custom manufactured to fit a specific structure and cured in place inside it. We have manufactured it in Northwest Florida for more than thirty years. For a typical manhole, the work is done in one shift and the line goes back in.

An eighty-three foot Triplex Liner hanging vertically from a crane above a live highway

The Triplex Liner System Is the Permanent Fix

We invented a different answer: not a coating sprayed on a failing wall, but a new structural wall cured in place inside the old one.

Two layers of structural fiberglass around a continuous corrosion barrier, fabricated for the exact structure it repairs. Patented, proven, and designed and tested to last up to 100 years in sewer conditions.

It is installed in cities across the United States, Canada and Australia, and we welcome work beyond them.

The inside of a finished lift station after Triplex Liner installation, looking down the wall to the floor
A finished lift station. One piece, wall to floor, built for this structure.

America's Sewer Structures Are Wearing Out

Every city runs on structures nobody sees: manholes, lift stations, wet wells. Sewer gas eats their concrete year after year, and that corrosion is what finally lets groundwater push through, as infiltration and as lost structural integrity. Cities have spent decades paying for temporary fixes to a permanent problem.

Groundwater infiltration running down the corroded wall of a sewer manhole
Groundwater and sewer gas working on the same structure.

How It’s Done

The short version of the installation manual: the liner is measured and custom built at the factory, the structure is prepped and the liner installed, and the structure goes back into service. For a typical manhole, the same day.

Engineers can request the full specification package. The disruption a city fears from rehabilitation is the part we engineered out.

Measured and Built
01

Measured and Built

Every liner starts at our factory in Northwest Florida, custom built to the measurements of the structure it will repair, in two pieces: the shaft and the bottom disc.

Prepped and Installed
02

Prepped and Installed

On site, the structure is cleaned back to sound wall. The crew saturates the liner, lowers it in, presses it into full contact with the structure, and cures it in place with steam and air.

Back in Service
03

Back in Service

The inlets and outlets are cut and reopened, and the structure returns to service with a new structural wall inside the old one. For a typical manhole, the same day.

Do It Right Once

A coating protects a surface until the surface fails again. A structural liner replaces what the structure lost, its strength and its corrosion protection, in one operation.

That is why cities that have tried both specify the liner. It turns a maintenance cycle into a finished repair.

A corroded metal culvert with the invert gone, open to daylight
Before.
The same culvert after Triplex Liner installation, looking through
The same culvert, lined.

Built for the Hard Ones

Some structures are critical to a city's health and nearly impossible to take offline: deep, downtown, on streets that cannot close. That is the work this system was built for. The liner goes in through the opening that is already there, one piece, sized to the structure, and the street is back the same day.

Working in Arizona

We work with Arizona municipalities, utility districts and consulting engineers on manhole, lift station and wet well rehabilitation. If rehabilitation is in your capital plan, we can help scope and specify it.

Three Ways In

Questions We Get in Arizona

Is this a coating?

No. It is a structural fiberglass liner fabricated for one structure and cured in place inside it.

What kinds of structures can be lined?

Manholes, lift stations, wet wells, pump stations and culverts, whatever their size or shape.

What does this do to our operations?

Less than most rehabilitation work. A typical manhole is out of service for a single shift and back in service the same day.

We have active infiltration. Is that a problem?

No. Being able to line a structure that is still taking water is one of the reasons the system was developed.

How long does it last?

The liner is designed and tested to last up to 100 years in sewer conditions. Standard manholes carry a twenty-year non-prorated materials warranty, and wet wells, pump stations and culverts carry five years.

Can we write this into a specification?

Yes. We issue a specification package to the engineer of record on request, with product data, section details and guide specification language.

Get Involved

Whether you manage a city's structures, write specifications, or install for a living, it starts with a conversation. Tell us what you are working with, and we will tell you honestly whether the Triplex Liner is the right fix and what the next step looks like.

Request a consultation